David Hingtgen Posted June 15, 2004 Share Posted June 15, 2004 Is there any quick and easy way to get all the sanding dust out of fine panel lines after a sanding session? It's even worse if you've been wet-sanding. The stuff just sticks like glue sometimes. Quote Link to comment Share on other sites More sharing options...
Akula Posted June 15, 2004 Share Posted June 15, 2004 I use a toothbrush... i find that going over the model a few times really gets the crud out. Quote Link to comment Share on other sites More sharing options...
bhop Posted June 15, 2004 Share Posted June 15, 2004 I use a fat paintbrush. It's a little softer than a toothbrush, but I guess either would work. Quote Link to comment Share on other sites More sharing options...
wm cheng Posted June 15, 2004 Share Posted June 15, 2004 Make sure your brush is wet too - otherwise its like sandpaper - the water really helps lubricate. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.