ChaoticYeti Posted November 23, 2015 Share Posted November 23, 2015 (edited) ALL CURRENTLY SPOKEN FOR Payment as paypal gift. $1.50 for a single piece, shipped within the continental US. $1.00 per piece if ordering more than one, shipped within the continental US. Get a pair FREE when ordering anything off of the YetiStand webstore. I have 12 black nubs, and 12 white nubs. The black ones appear to be white that have been dyed black. I do not know if that will affect fitment. This is the same nub I used to repair my Arcadia VF-0A. These are very small 3d printed pieces. There are caveats to 3d printing that, if you are not familiar with 3d printing, make it difficult to guarantee their effectiveness. By buying one of these YOU are doing the QC test. Feedback is appreciated. When they are gone, they are gone. That's 24 for now. I am trying to get them for sale on Shapeways as well, but it gets kicked back when anyone other than me tries to order them due to the tolerances on such a small piece. If you use one to repair your hip, please post you comments here: http://www.macrossworld.com/mwf/index.php?showtopic=42180&page=1 Edited November 24, 2015 by ChaoticYeti Link to comment Share on other sites More sharing options...
no3Ljm Posted November 23, 2015 Share Posted November 23, 2015 PM sent. Link to comment Share on other sites More sharing options...
ChaoticYeti Posted November 23, 2015 Author Share Posted November 23, 2015 PM sent. 6 white are spoken for. Link to comment Share on other sites More sharing options...
Xigfrid Posted November 23, 2015 Share Posted November 23, 2015 PM sent! Link to comment Share on other sites More sharing options...
Loop Posted November 24, 2015 Share Posted November 24, 2015 Hey Yeti, is there any reason I should order some of these over your initial non shapeways run that you made for me? Link to comment Share on other sites More sharing options...
ChaoticYeti Posted November 24, 2015 Author Share Posted November 24, 2015 Hey Yeti, is there any reason I should order some of these over your initial non shapeways run that you made for me? Up to you. I am not going to open mine back up to put the one I printed back in. I would suggest taking the leg apart as few times as possible. If you are happy with the printed ones I made, stick with them. I used the same 3d mesh. Link to comment Share on other sites More sharing options...
ChaoticYeti Posted November 24, 2015 Author Share Posted November 24, 2015 And, they are gone. Link to comment Share on other sites More sharing options...
Recommended Posts