Iceblue106 Posted February 11, 2010 Share Posted February 11, 2010 Hello all, Well I have this terrible tendency to want to tinker with things. Whenever I get a new toy I have the curiosity of a cat of just how its put together and how it could be improved and/or modified. So with that said I have decided to start this thread and share a little Tomahawk love. (which may be horror to some of you) My first pictures are what I like to call my promo pictures. Anyways this thread is designed to walk you through steps of disassembling your hawk and adding the modifications should you wish to do the same. Otherwise you can just sit back and watch in either horror or in pleasure as I work some wonders. With that said welcome to the pictures... Note: Precision tools are required for the following procedures. In the first steps I have decided to take apart the shoulder mounted light fixture. The modification it is one I'm sure most would dream of doing themselves, that being the installation of a white LED for a somewhat realistic addition to the hawk. Quote Link to comment Share on other sites More sharing options...
AcroRay Posted February 11, 2010 Share Posted February 11, 2010 I take it you don't have the search-light's LED set up to be fully internal? I'm curious if anyone has developed anything that can be isolated into the search-light housing. Most of the inexpensive dollar-store toys I can find usually require 3 batteries and a resistor or two, which is a bit much to pack in there. Quote Link to comment Share on other sites More sharing options...
Iceblue106 Posted February 12, 2010 Author Share Posted February 12, 2010 (edited) I take it you don't have the search-light's LED set up to be fully internal? I'm curious if anyone has developed anything that can be isolated into the search-light housing. Most of the inexpensive dollar-store toys I can find usually require 3 batteries and a resistor or two, which is a bit much to pack in there. I've actually been doing some tinkering with this concept/idea and have made minimal progress... I was trying to fit a standard 9volt battery within the back of the Hawk itself. It fits dimensionally with some minor trimming of the mounting posts. (internally) However the battery unfortunately is too thick and leaves about an 1/8 inch gap when you try to install the back plate. Sadly because of this I have decided to do a complete internal wiring and have an out source power connector. (plug in method if you will) Regardless I will post more on that later on. For now I will include pictures of the attempt to install the 9 volt battery below. To disassemble the chest section you need to pull off the arms and then pull out the chest missile packs. Once these are removed as well as the cockpit and upper head cover, you will be able to see the 3 screw locations that enable access to the inside. Remove these and then on the base of the back, pull the exhausts outwardly (front to back direction) With this done you can remove the back cover as well as the side shoulder mounts and gain access to the internals. Blue Edited February 12, 2010 by Iceblue106 Quote Link to comment Share on other sites More sharing options...
valhary Posted February 12, 2010 Share Posted February 12, 2010 congratulations thats exactly the way that yamato should made this Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.